Subtotal: $0.00
The order subtotal is less than the minimum allowed value ($3.90)
These awesome silicone duck call molds by Jake Thomson create 2 x 2 x 4 blanks and fit perfectly into the widely used 2.5-gallon pressure pot. The outside size of the mold is 5 inches long x 3 inches wide x 2 3/4 inches tall. The depth of the pouring area is 2.25 inches deep, so you can pour 2 inches and have .25 inches left before it overflows. This means no spilling on the way to the pressure pot. These are exceptional-quality silicone molds!
Jake Blank Molds - Silicone Duck Call Mold
These fantastic silicone duck call molds, designed by Jake Thomson, create blanks measuring 2 x 2 x 4 and perfectly fit the commonly used 2.5-gallon pressure pot. The mold's dimensions are 5 inches in length, 3 inches in width, and 2 3/4 inches in height. With a pouring area depth of 2.25 inches, you can pour up to 2 inches without any spillage during transportation to the pressure pot. These silicone molds are of exceptional quality!
For longevity, it's recommended to use mold release to preserve the mold's lifespan.
For use with Alumilite, polyester, and most epoxy resins
The resin will be matte where it comes in contact with the mold. To appear shiney in these areas, you will need to polish it or apply a finish. Depending on the resin that you use, the top area on the blank (not in contact with the mold) will normally appear as shiney
