The order subtotal is less than the minimum allowed value ($3.00)
Insta-Cure has a water-thin viscosity that wicks deep into joints by capillary action and cures in a matter of a few seconds.
Please choose the size of bottle from the drop down menu below.
BSI Insta-Cure Super Thin CA Glue.
Insta-Cure™ has a water-thin viscosity that wicks deep into joints by capillary action and cures in a matter of a few seconds. Surfaces to be bonded must be tight fitting and should be held together while you apply the CA around the edges of the seam. At the moment CAs cure, they give off a vapor that can irritate the nose and eyes, so be prepared. Thin CAs work very well on balsa since they penetrate into the wood and form more than just a surface bond.
Available Sizes:BSI-101: 1/2 oz (14.2 g)BSI-102: 1 oz. (28.4 g)BSI-103: 2 oz. (56.8 g)BSI-104: 8 oz. (227 g)
Mix & Match with other Adhesives to obtain the best quantity discounts!
Directions for Use
Unscrew top from nozzle. For finer applications, use the extender tip. Insta-Cure™ CA is used to bond tight fitting parts. Hold the parts together (sometimes using masking tape), then apply the Insta-Cure™ along the joints. The CA will penetrate deep into the joints. Bonding will occur in 1-3 seconds. Excess cured CA can be removed from surfaces like ceramics by rubbing with a paper towel soaked in Un-Cure™. Full strength is reached in two hours. Wipe the nozzle clean before replacing screw-on top. Refrigerate to extend shelf life. Cured CA is stable from -40 to 220º F. Soak extender tip in acetone for cleaning.
© 2006 - 2020 Exotic Blanks. All rights reserved.