Subtotal: $0.00
The order subtotal is less than the minimum allowed value ($3.90)
Pen Blank Squaring Jig (V Block)
Square the ends of any pen blank easily and safely! No more pen mill chip-outs! Choose the correct size transfer punch that will fit your blank (Punch set can be found here ) and mounts it in the V groove. You are then ready to perfectly trim your blanks ends on your disc sander.
The small jig will fit 6" and smaller disc sanders, the large jig is for 6" and above.
Dimensions of fixture: 5" x 1" x 1.25"h
Pen Blank Sanding Squaring Jig (V Block)
Square the ends of any pen blank easily and safely! No more pen mill chip outs! Choose the correct size transfer punch that will fit your blank (Punch set can be found here ) and mount it in the V groove. You are then ready to perfectly trim your blanks ends on your disc sander.
Hi Paul, the larger jig was discontinued.
You secure a punch to the v block with the provided attachment screw. When locked in it will hold your blank square to your sander. This video from Mark Dreyer may help explain - https://www.youtube.com/watch?v=YoqiTHerVk8
Hi David, Essentially the punch holds your blank between the jig and the sanding disc. Pick a punch that fits inside the tube of the blank that you are sanding. The punch then fits into the v groove of the jig and extends beyond to the sanding disc. The blank slides onto the extended part of the punch & face away! I hope that helps make it clearer. Dawn